Operation - Wacker Neuson G 100 Notice D'emploi

G 100 / G 120
4.14

Operation

Switch Leave the engine start switch (f) in the START/RUN position while the generator is
positions
operating.
If the generator was started using a remote switch, leave the engine start switch in
the REMOTE START position.
R
Let the generator run for a few minutes to warm the engine before closing the main
circuit breaker.
CAUTION
Possibility of unexpected equipment start-up.
Disconnect all attached electrical devices before starting the machine.
Before closing breakers, make sure that any electrical devices attached down-
stream from the generator will not start up unexpectedly.
Before placing the engine start switch in the REMOTE START position, verify
that the contacts on any remote switch linked to the generator set are open.
This will prevent the generator from immediately starting when the engine start
switch is moved to the REMOTE START position.
While the generator is running, check for excessive vibration, oil leaks, or coolant
leaks.
wc_tx001687gb.fm
V Ø A HZ
REMOTE START REMOTE START
DIAGNOSTICS
DIAGNOSEN ARRANQUE REMOTO ARRANQUE REMOTO
DIAGNOSTICOS
DIAGNOSTICS
f
OFF OFF
AUS AUS
APAGADO APAGADO
ARRET ARRET
START / RUN START / RUN
FERNSTART FERNSTART START / LAUFEN START / LAUFEN
ARRANQUE / MARCHA ARRANQUE / MARCHA
DEMARRAGE A DEMARRAGE A DEMARRER / MARCHE DEMARRER / MARCHE
DISTANCE DISTANCE
47
Operation