Wacker Neuson G 100 Notice D'emploi page 46

Operation
10. See Basic Troubleshooting to identify possible causes and remedies for the
starting problem. Correct the problem before attempting to start the engine
again.
11. To repeat crank cycle, return start switch to off "O" to reset engine control
module. Allow starter motor to cool between start-up attempts.
After starting After the engine starts, allow it to warm up for a few minutes and check the
readouts on the LCD panel.
Make sure battery charging system, oil pressure, and engine temperature
readings are within normal ranges.
Check that AC voltage is correct. Voltage can be fine-adjusted by turning the
voltage adjustment rheostat on the metering panel.
Check frequency. The frequency should read 60 Hz.
R
k
h
p
V Ø A HZ
DIAGNOSTICS
DIAGNOSEN
DIAGNOSTICOS
DIAGNOSTICS
V Ø A HZ
DIAGNOSTICS
DIAGNOSEN
DIAGNOSTICOS
DIAGNOSTICS
R
f
OFF OFF
AUS AUS
APAGADO APAGADO
ARRET ARRET
START / RUN START / RUN
REMOTE START REMOTE START
START / LAUFEN START / LAUFEN
FERNSTART FERNSTART
ARRANQUE REMOTO ARRANQUE REMOTO ARRANQUE / MARCHA ARRANQUE / MARCHA
DEMARRAGE A DEMARRAGE A DEMARRER / MARCHE DEMARRER / MARCHE
DISTANCE DISTANCE
v
OFF OFF
AUS AUS
APAGADO APAGADO
ARRET ARRET
REMOTE START REMOTE START START / RUN START / RUN
FERNSTART FERNSTART START / LAUFEN START / LAUFEN
ARRANQUE REMOTO ARRANQUE REMOTO ARRANQUE / MARCHA ARRANQUE / MARCHA
DEMARRAGE A DEMARRAGE A DEMARRER / MARCHE DEMARRER / MARCHE
DISTANCE DISTANCE
46
G 100 / G 120
120 / 208
3Ø
277 / 480 120 / 240
3Ø
a
wc_gr006140
wc_tx001687gb.fm