Cleaning The Sediment Cup; Adjusting The Carburetor - Wacker Neuson GP2500A Manuel D'utilisation

Maintenance
5.6

Cleaning the Sediment Cup

1. Turn the fuel valve off.
2. Remove the sediment cup (a) and
the O-ring (b).
3. Wash the sediment cup in a
nonflammable solvent.
4. Dry and install the sediment cup.
5. Replace the O-ring with a new one.
6. Turn the fuel valve on and check for
leaks.
5.7

Adjusting the Carburetor

1. Start the engine and allow it to warm up to operating temperature.
2. Set the pilot screw (a) two turns out. See Note.
3. With the engine idling, turn the pilot screw (a) in or out to the setting that
produces the highest rpm.
4. After the pilot screw is adjusted, turn the throttle stop screw (b) to obtain the
standard idle speed. See Technical Data.
Note: On some engines the pilot screw is fitted with a limiter cap (c) to prevent
excessive enrichment of the air-fuel mixture in order to comply with emission
regulations. The mixture is set at the factory and no adjustment should be
necessary. Do not attempt to remove the limiter cap. The limiter cap cannot be
removed without breaking the pilot screw.
c
a
48
b
a
b
wc_tx004574gb.fm
GP
wc_gr000029
wc_gr010584