Preparatory Work; Lifting The Machine - Wacker Neuson GP2500A Manuel D'utilisation

Item Part Number
1 5000177375
2 5000177374
3 5000177377
4 5000177376
5 5000177378
6 5000177379
7 5000171857
8 5000171858
9 5000177380
10 5000177381
11 5000177382
12 5000177386
13 5000171855
14 5000177389
15 5000171803
16 5000177390

Preparatory work

1. Stop the engine.
2. Remove the ignition key.
3. Verify that all wheel kit parts are present.
wc_tx004653en.fm
Continued from the previous page.
Quantity
1 Right handlebar
1 Left handlebar
1 Right support bracket
1 Left support bracket
1 Axle shaft
2 Wheels
2 M20 washers
2 Cotter pins
1 Main support bracket
1 Spacer
2 Cushion mounts
6 M8 x 20 bolts
8 M8 x 16 bolts
3 M6 x 28 bolts
14 M8 nuts—Tighten to a torque of 18-25 Nm (13-18 ft. lbs.)
3 M6 nuts—Tighten to a torque of 8-12 Nm (6-9 ft. lbs.)
This procedure continues on the next page.
Assembly Instructions—Wheel Kit
Description

Lifting the machine


CAUTION
This machine, while compact, is heavy
enough to cause injury if proper lifting
techniques are not used. Observe the
following guidelines when lifting the
machine.
• Do not attempt to lift and carry the machine
unassisted.
• Use appropriate lifting equipment such as slings,
chains, hooks, ramps, or jacks.
• Make sure lifting equipment is attached securely and
has enough weight-bearing capacity to lift or hold the
machine safely.
3