Unpacking - De Dietrich DPI7884XT Manuel D'utilisation

1.1 UNPACKING

Remove all the protective elements from
the hob, the sensor and the sensor
stand.
Your sensor is delivered with a battery
that you have to install (1.0). To insert
the battery, unscrew the cover on the
1.0
back of the sensor using a coin. Insert
the battery following the polarity (+
upwards), then screw the cover back on.
Check and respect the characteristics
of the appliance on the manufacturer's
nameplate (1.1.1).
Note the service and standard references
shown on this plate in the boxes below
for future reference.
1.1.1
Type:
Service:
1. 2 BUILDING INTO A BASE UNIT
Check that the air intakes and outlets are
free of obstruction (1.2.1). Comply with
the information concerning the fitting
dimensions (in millimetres) of the base
unit destined to receive the hob.
- Fitting into the worktop
See diagram (1.2.2)
1.2.1
64
64
R 3
10
25
R 3
1.2.3
1.2.2
8