De Dietrich DPI7884XT Manuel D'utilisation page 64

- Fitting flush with the worktop See
diagram (1.2.3)
Check that air can flow correctly between
the front and back of your hob.
If you are installing the hob above a
drawer (1.2.6) or above a built-in oven
(1.2.7), comply with the dimensions
provided on the illustrations to ensure
a sufficient air outlet at the front. Apply
the seal all around the edge of the hob
(1.2.8).
Fit the hob into the base unit (1.2.9).
If your hob is located above your
oven, the hob's thermal safety devices
can impede the simultaneous use of the
hob and the oven's pyrolysis programme.
Your hob is equipped with an overheating
prevention safety system. This safety
device can trigger, for example, when
the hob is installed over an oven that is
not sufficiently insulated. The code "F7"
then appears in the control zone. In such
circumstances we recommend that you
increase the hob's ventilation by creating
an opening in the side of the cabinet
(8cm x 5cm).
9