De Dietrich DPI7884XT Manuel D'utilisation page 71

2
•
USE
Using the sensor
To operate the sensor, you need
to switch it on (press the button for
several seconds); switch on the hob
and then select a burner. When setting
the temperature, the hob automatically
adjusts the necessary power which may
cause a difference in boiling.
Thermometer function
This function shows on the hob display
the temperature measured by the sensor
(range 5° - 180°C).
This function provides temperature
information.
This function can be used to measure
the temperature of a dish being cooked
on the hob or of a roast taken out of the
oven, for example.
If there is no cookware, the temperature
and "°C" flash on the burner's display.
The sensor temperature is refreshed
every 1.5 seconds.
Cooking functions
To access the different cooking functions,
turn on the hob, select the burner (if there
is no cookware, a 0 flashes), then press
the symbol of the required pre-defined
function.
In these functions, cooking is driven by
the sensor.
For all functions, except the melting
function:
- the sensor must be at least 1 cm from
the base of the pan.
- the sensor must be immersed by at
least 1 cm in the food to be cooked.
If this is not possible, adapt the diameter
of the pan and the burner to the quantity
to be cooked.
It is recommended to regularly stir
the contents of your cookware during
cooking.
To access the different functions:
Press the specific key for the function
+
(then on or
the recommended temperature). The
temperature is displayed for 5 seconds,
then the "°" is shown until the setpoint
temperature is reached. The selected
function is shown alternately with the
temperature. There is a beeping sound
to indicate that the "°" has been set. The
temperature will be maintained until you
switch off the burner.
16
1 cm
1 cm
-
if you want to modify