diagral TT385 Guide De Pose page 66

You wish to change one of your corre-
spondent's numbers...
Perform the operations below (telephone dialler
fixed to the wall):
n° in memory
(20 digits max.)
1 st number =
1
2 nd number =
2
3 number =
rd 3
Every time you press a key the telephone dialler
announces the recorded digit.
The telephone dialler emits a long BEEP to confirm
the number has been recorded (the old number is
written over).
The telephone dialler emits three short BEEP's to indi-
cate an error in the recording procedure.
Every time you record a new number, check it and
then make a test call to it.
You wish to check one of your corre-
spondent's numbers...
Perform the operations below:
n° in memory
to be checked
(1 to 3)
Your telephone dialler announces the number
recorded in the memory you wish to check.
QUICK USER GUIDE
...
telephone n°
You wish to perform a test call...
First let your correspondent know that you
are going to make a test call to their home.
Perform the operations below:
n° in
memory
to be checked
(1 to 3)
The telephone dialler announces the content of the
memory and then emits a long BEEP.
During the long BEEP, press on the tele-
phone dialler's Emergency key for 3 sec-
onds.
The LED indicating there is a telephone dialler call in
progress lights up.
The telephone dialler automatically dials your cor-
respondent's telephone number saved to the memo-
ry. It sends your correspondent a test call message
(a voice synthesised message for your friends and
family and a digital message for the remote monitor-
ing centre),
At the end of the message, the LED indicating
there is a call in progress goes out. The test call is
over.
Check that your correspondent has received the
call.
If the correspondent is new, explain to them how
to stop the telephone dialler call cycle (refer to the
instructions sheets).
42
...
long BEEP
" "
announ-
cement of
number
Emergency
checked