diagral TT385 Guide De Pose page 31

YOUR TELEPHONE DIALLER ALERTS YOUR FRIENDS AND FAMILY
2.1 Telephone dialler call cycle when a remote alarm is triggered
You have three call numbers. If the first correspondent does not pick up the call or if the line is
engaged, the telephone dialler calls the next number stored in the memory. If none of the
!
three correspondents picks up the call, the dialler continues the call cycle as described below:
NUMBER
1
1
1 min.
NUMBER
2
2
wait
NUMBER
3
3
You can put a stop to your dialler's call cycle from your home by sending an OFF order
using your remote control or keypad.
2.2 Your telephone dialler's synthesised voice messages
Your telephone dialler delivers a message corresponding to the event having triggered the call.
You must inform your correspondents of the procedure to be followed depending on the type of mes-
sage received (go to your home, call the police or fire brigade, etc.).
Emergency call or system anti-tamper triggered
Dialler anti-tamper triggered
Single intrusion: only 1 intrusion detector triggered
Confirmed intrusion: two intrusion detectors triggered
in less than 70 seconds
Fire detected
Power cut, freeze, freezer breakdown or flood detected "BEEP, SYSTEM N°, TECHNICAL ALARM"
Silent alarm
Alarm system battery low indication
Dialler battery low indication
Test call*
N°: your telephone dialler identification number, which may be replaced with a personalised identifi-
cation message.
* You can use the test call to test that your telephone dialler is working with your friends and family.
1
6 min. 1 min.
2
wait wait
3
Automatically stops
Events
2
1
2
3
Voice messages
"BEEP, SYSTEM N°, EMERGENCY "
"BEEP, SYSTEM N°, ANTI-TAMPER, DIALLER"
"BEEP, SYSTEM N°, INTRUSION"
"BEEP, SYSTEM N°, INTRUSION
CONFIRMED"
"BEEP, SYSTEM N°, FIRE ALARM"
"BEEP, SYSTEM N°, SILENT ALARM"
"BEEP, SYSTEM N°, BATTERIES LOW,
SYSTEM"
"BEEP, SYSTEM N°, BATTERIES LOW,
DIALLER"
"BEEP, SYSTEM N°, TEST"
7
2