diagral TT385 Guide De Pose page 62

Press the OFF key on your remote control or ask the person standing next to the keypad to enter
the OFF command on the keypad. Once the OFF order has been given, move the telephone
dialler away from the wall within 3 seconds.
If the telephone dialler is triggered, gently press the OFF key on your remote control for four
seconds or ask the person next to the keypad to enter the OFF command. Once removed from
the wall and given the OFF order the telephone dialler switches to test mode.
When hand-held the telephone dialler is in test mode. Do not be surprised if you hear it beeping
or crackling.
Open the battery access flap with a screwdriver. Remove the batteries and replace them
with new ones.
If your telephone dialler calls a remote monitoring centre, check the numbers in the memory
by dialling:
Memory n°
to be checked
(1, 2, 3, 4, 6)
Close the battery flap.
Fix the telephone dialler in place. The telephone dialler switches from test mode to normal operat-
ing mode.
If your telephone dialler calls your friends or family, check the numbers in the memory by dialling:
Memory n°
to be checked
(1 to 3)
Reconnect the dialler to the telephone line.
Make a test call (see chapter 11.1).
This device has a "PSTN public network analog access type" interface. The circuit is classed
!
as a TNV (Telecommunications network voltage) circuit as defined in standard EN 41 003.
13
The numbers and parameters initially
programmed remain in the memory.
" ........ "
Programmed
number
announced
38
A