Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
You are now going to programme your telephone dialler with a personalised radio code:
if you are adding the telephone dialler to an existing alarm system, use the DIAGRAL system
remote control or keypad and follow the telephone dialler recognition programming operations
(see chapter 5.1),
if you are not adding the telephone dialler to a previously coded alarm system (e.g. use with pen-
dant), follow the operations outlined in chapter 5.2.
5.1
Programming your alarm system's personalised radio code
The personalised radio code must be programmed in "Test" mode (anti-tamper pin
released).
5
Use an alarm system remote control or keypad.
Programming the radio code using a remote control
TT385
0
2
4
6
8
1
3
5
7
9
MIC
Press on the dialler's
key and then on the
the dialler confirms by emitting
a long "BEEP".
CODING YOUR TELEPHONE DIALLER
"BEEP"
Urgence
Service
then
key:
5
10 sec. max
Press and hold the
"OFF"
key on your remote control
14
"BEEP"
TT385
0
2
4
6
8
Urgence
1
3
5
7
9
Service
MIC
The telephone dialler emits
a long
"BEEP"
to confirm
correct programming
of the personalised radio code.
Publicité
Chapitres
Table des Matières
