Dustbane Gladiator 1280 Manuel D'opération page 16

Periodic Checks
Checks
Check the battery electrolyte
Check the hydraulic oil
Check the condition of the belts
Adjust the brake
Check the tightness of nuts and bolts
Check the condition of the brushes
Check the tightness of the seals
Check the functioning of devices
Grease the steering chain
Troubleshooting
Problem
The machine raises dust
The machine leaves dirt on the ground
The main brush does not rotate
The side brushes do not rotate
The suction motor does not work
The filter shaker motor does not work
16
Operations Manual
Cause
Filter clogged. (B,DP,P,D)
Filter damaged. (B,DP,P,D)
Filter incorrectly fitted. (B,DP,P,D)
The main brush is not adjusted correctly
or is worn. (B,DP,P,D)
The main brush has collected string or
wire. (B,DP,P,D)
The flaps are damaged. (B,DP,P,D)
Replace the flaps.
Belt broken.
Fuse burned out.
Microswitch faulty.
Cable disconnected.
Gearmotor faulty.
Cutout tripped.
Microswitch faulty.
Cable disconnected.
Fuse burned out.
Switch faulty.
Cable disconnected.
Motor faulty.
Fuse burned out. (B,DP,P,D)
Switch faulty. (B,DP,P,D)
Cable disconnected. (B,DP,P,D)
Motor faulty. (B,DP,P,D)
Gladiator 1280
Daily Weekly
Operations Operations
X
X
X
X
X
X
X
Remedy
Shake the filter with the filter shaker
and, if necessary, remove and clean it
thoroughly.
Replace the filter.
Fit the filter correctly in its housing.
Adjust or replace the main brush as
necessary.
Remove the string and wire picked up.
Replace the flaps.
Empty the debris bin.
Replace.
Replace.
Replace.
Check.
Replace.
Reset.
Replace.
Check.
Replace.
Replace.
Check.
Replace.
Replace.
Replace.
Check.
Replace.
Six Monthly
Operations
X
X