Dustbane Gladiator 1280 Manuel D'opération page 11

Operating Instructions
• Sit correctly in the seat.
• Turn the main switch to position "1".
• Check that the display shows the batteries to be fully charged. Recharge if necessary. See
the "Battery maintenance and charging" section.
• Select the direction of travel with the direction selector.
• Release the parking brake.
• Lower the side brushes.
• Lower the main brush.
• Press the accelerator pedal to move off and start work.
• Press the flap lift pedal only when you need to pick up large but light objects.
• Cleaning quality depends largely on the cleanliness of the suction filter. Operate the filter
shaker at intervals suitable to the environment in which you are using the machine.
Emptying the top unloading debris bin
• Press and hold the bin movement enabling button (1, fig. 29) then operate the bin up/down switch (2, fig. 29) to raise the
bin to the required height.
• Pull the lever (fig. 7) to rotate the bin and empty its contents.
• Turn the bin back to its horizontal position.
• Press and hold the bin movement enabling button (1, fig. 29) then operate the bin up/down switch (2, fig. 29) to lower
the bin again.
Finishing Work
When you finish work, switch the machine off at the main switch, lift the side brushes and mainbrush and engage the parking
brake.
Moving the machine when not in operation
• Raise the side brushes.
• Raise the main brush.
• Select the direction of travel.
• Press the accelerator pedal.
Emptying the top unloading debris bin
When emptying the bin, always wear a mask to protect the respiratory tract from the dust
which is always present during this operation.
Before emptying the debris bin, operate the filter shaker for 30 seconds to clean the filter
! IMPORTANT!
When you open the bin, all functions are disabled on Battery and Dual Power versions, and
the engine is also switched off on the Dual Power version.
► Press and hold the bin movement enabling button (1, fig. 29) then operate the bin up/down
switch (2, fig. 29) to raise the bin to the required height.
► Pull the lever (fig. 7) to rotate the bin and empty its contents.
► Turn the bin back to its horizontal position.
► Press and hold the bin movement enabling button (1, fig. 29) then operate the bin up/down
switch (2, fig. 29) to lower the bin again.
7
Finishing work
! IMPORTANT!
Shake the filter at the end of every work session.
Operations Manual
When you finish work, switch the machine off at the main switch, lift the side brushes and main
brush and engage the parking brake.
! WARNING!
! WARNING!
29
1
Gladiator 1280
2
11