Dustbane Gladiator 1280 Manuel D'opération page 14

Replacing/installing the suction filter
The suction filter makes a major contribution to the efficiency of the whole
machine. Its correct maintenance keeps the machine at maximum efficiency
at all times. If the sweeper begins to raise dust as it sweeps, check the
condition of the suction filter. The suction filter can be cleaned in two ways.
Semiautomatic filter cleaning:
This method provides a quick and easy way to keep the suction filter clean
and ready for work. Press and hold the filter shaker button for a number of
seconds, then repeat four or five times. On Petrol and Diesel versions, shut
off suction with the suction control lever before pressing the filter shaker
button.
Manual cleaning of the panel filter:
! DANGER: This operation must be performed with the machine switched off and
the key removed.
If the action of the filter shaker proves insufficient, proceed as follows to
clean the filter manually.
• Remove the filter compartment cover.
• Lift the two levers and remove the filter shaker bracket complete with the filter shaker motor, carefully disconnecting the
power cable from the filter shaker (fig. 23).
• Remove the suction filter (fig. 23).
• Blow the filter clean with compressed air (maximum pressure 6 bar).
Manual cleaning of the pocket filter:
.
! DANGER: This operation must be performed with the machine switched off and the key removed.
If the action of the filter shaker proves insufficient, proceed as follows to clean the filter manually.
• Remove the filter compartment cover.
• Unscrew the four screws securing the two filter holder brackets (fig. 24).
• Remove the two brackets (fig. 24).
• Remove the filter, carefully disconnecting the power cable from the filter shaker (fig. 24).
• Blow the filter clean with compressed air (maximum pressure 6 bar).
14
Operations Manual Gladiator 1280
► Remove the suction filter (fig. 23).
► Blow the filter clean with compressed air (maximum pressure 6 bar).
The filter is marked to show the correct direction for fitting.
23
Manual cleaning of the pocket filter:
FLOW
This operation must be performed with the machine switched off and the key removed.
If the action of the filter shaker proves insufficient, proceed as follows to clean the filter manually.
► Remove the filter compartment cover.
► Unscrew the four screws securing the two filter holder brackets (fig. 24).
► Remove the two brackets (fig. 24).
► Remove the filter, carefully disconnecting the power cable from the filter shaker (fig. 24).
► Blow the filter clean with compressed air (maximum pressure 6 bar).
Manual cleaning of the pocket filter:
24
This operation must be performed with the machine switched off and the key removed.
If the action of the filter shaker proves insufficient, proceed as follows to clean the filter manually.
► Remove the filter compartment cover.
► Unscrew the four screws securing the two filter holder brackets (fig. 24).
► Remove the two brackets (fig. 24).
► Remove the filter, carefully disconnecting the power cable from the filter shaker (fig. 24).
► Blow the filter clean with compressed air (maximum pressure 6 bar).
24
! IMPORTANT!
! DANGER!
! DANGER!
GB
GB
32
32