Yamaha WaveRunner GP1300R 2003 Manuel D'atelier page 478

HULL
HOOD
HANDLEBAR
3. Install:
• Throttle cable
NOTE:
Fit the seal into the groove in the bracket.
4. Install:
• Plastic tie 1
NOTE:
After inserting the QSTS cables and throttle
cable into the grommet, fasten the end of
grommet with the plastic tie.
5. Install:
• Handlebar cover 1
NOTE:
When the handlebar cover is in contact with
the steering console cover, adjust the handle-
bar mounting angle so that clearances a and
b are equal.
6. Adjust:
• Throttle lever free play
Refer to "CONTROL SYSTEM" in Chap-
ter 3.
7. Adjust:
• QSTS cable
Refer to "CONTROL SYSTEM" in Chap-
ter 3.
8-7
E