Yamaha WaveRunner GP1300R 2003 Manuel D'atelier page 338

Table des Matières

Publicité

JET
PUMP
BEARING HOUSING
1
SERVICE POINTS
Driven coupling removal and installation
1. Remove and install:
• Driven coupling
Driven coupling:
36 N • m (3.6 kgf • m, 25 ft • lb)
LOCTITE 572
Coupler wrench:
YW-06551/90890-06551
Shaft holder:
YB-06552
Crankshaft holder 20:
90890-06552
NOTE:
Install the driven coupling with the same spe-
cial service tools that were used for removal.
Intermediate drive shaft removal
1. Remove:
• Intermediate drive shaft
Removal steps:
• Temporarily install the driven coupling to
the intermediate drive shaft.
• Insert a long rod to the intermediate drive
shaft.
• Press out the intermediate drive shaft by
pushing the rod.
NOTE:
Support the intermediate housing with steel
blocks 1 and press the intermediate drive
shaft with a rod that is more than 280 mm
(11.02 in) long, and which has an outer diame-
ter less than 13 mm (0.51 in).
6-20
E

Publicité

Chapitres

Table des Matières
loading

Table des Matières