Lenze ECS Série Instructions De Montage page 135

Via the 9−pole Sub−D−plug X8, you can connect the following encoders:
Incremental encoder (TTL encoder)
ƒ
–
with two 5 V complementary signals (RS−422) that are electrically
shifted by 90°.
–
Optionally, the zero track can be connected.
SinCos encoder
ƒ
–
with supply voltage (5 ... 8 V).
–
with serial communication (single−turn or multi−turn; the initialisation
time of the axis module is extended to approx. 2 s).
The controller supplies the encoder with voltage.
Use C0421 to set the supply voltage V
voltage drop [DV] on the encoder cable:
DU ^ 2 @ L
DV
Voltage drop on the encoder cable [V]
L Cable length [m]
L
R/m Ohmic resistance per meter of cable length [W/m]
I Encoder current [A]
G
(
Stop!
Observe the permissible supply voltage of the encoder used. If the
values in C0421 are set too high, the encoder can be destroyed!
EDKCSEX064 DE/EN/FR 4.0
[m] @ R m [W m] @ I
L
l
Electrical installation
Wiring of the feedback system
Encoder connection
(5 ... 8 V) to compensate, if required, the
CC
[A]
G
4
135