Obtaining The Two Fuel Samples - Kent-Moore J-44175-A Manuel D'instructions

Gasoline and gasoline vapors are highly
flammable. To avoid risk of personal injury
perform test away from open flames, sparks
and any other potential sources of ignition.
In order to reduce the risk of fire and
personal injury use extreme caution when
connecting and disconnecting gage to
fuel rail.
Turn ignition off. Remove gas cap. Connect either
the J-34730-FF orange-face pressure gage or the
CH-48027 Digital Pressure Gage to the fuel rail
pressure connection. Use a shop towel around the
fitting to avoid fuel spillage.
If fuel system components are to be serviced, relieve
the fuel system pressure before servicing the fuel
system components to reduce the risk of fire and
personal injury.
After relieving the system pressure, a small amount
of fuel may be released when servicing the fuel
lines or connections. In order to reduce the chance
of personal injury, cover any fuel line fittings with
a shop towel before disconnecting. This will catch any
fuel that may leak out. Place the towel in an approved
container when the disconnection is complete.

Obtaining the TWO fuel samples

Each fuel sample will be taken at different
times. Each fuel sample will be tested
differently.
21