Obtaining The Two Fuel Samples - Kent-Moore J-44175-A Manuel D'instructions

Obtaining the TWO fuel samples

Each fuel sample will be taken at different times.
Each fuel sample will be tested differently.
Flush out the gage hose with the test vehicle's fuel
before taking any fuel samples used for testing.
1. Connect the fuel pressure gage to the
fuel rail.
2. Insert the gage's bleed hose into an approved
container. Do not use the 100mL beaker for
this flushing procedure.
3. Turn the ignition switch to the ON position. DO
NOT START THE ENGINE.
4. Command the fuel pump ON with the scan tool.
5. Slowly open the bleed valve on the fuel pressure
gage, until the gage hose has been flushed.
The FIRST fuel sample is used to test
for water or sediment in the fuel.
The first fuel sample is not to be used in the
J-44175-A tester. After the first fuel sample is
tested for water or sediment, that sample is to be
discarded. Fuel should be disposed of in accordance
with all applicable federal, state and local
requirements.
The SECOND fuel sample is to be used
in the J-44175-A tester.
Use either the J-34730-FF orange-face
pressure gage or the CH-48027 Digital
13