Kent-Moore J-44175-A Manuel D'instructions page 10

CH-48027
Figure 7
Alcohol-resistant
gauge/hose/fittings
assembly
outside debris to contaminate the fuel sample, beaker,
tester or fuel gage as this will cause an error in the
test result, leading to a misdiagnosis.
TWO fuel samples are to be taken, with different
tests on each sample. Fill the 100mL beaker to
the 100mL mark on the beaker for each sample.
Gasoline and gasoline vapors are highly
flammable. To avoid risk of personal injury
perform test away from open flames, sparks
and any other potential sources of ignition.
In order to reduce the risk of fire and
personal injury use extreme caution when
connecting and disconnecting gage to
fuel rail.
Turn ignition off. Remove gas cap. Connect
either the J-34730-FF orange-face pressure
gage or the CH-48027 Digital Pressure Gage to
the fuel rail pressure connection. Use a shop
towel around the fitting to avoid fuel spillage.
If fuel system components are to be serviced,
relieve the fuel system pressure before servicing
the fuel system components to reduce the risk
of fire and personal injury.
After relieving the system pressure, a small amount
of fuel may be released when servicing the fuel
lines or connections. In order to reduce the chance
of personal injury, cover any fuel line fittings with
a shop towel before disconnecting. This will catch
any fuel that may leak out. Place the towel in an
approved container when the disconnection is
complete.
12