Husqvarna P 520DX Manuel D'utilisation page 48

2d: Pump – power steering
3b: Front transmission – filter
3a: Rear transmission – filter
3c: Rear transmission – front transmission
4a: Power steering – steering cylinder
4b: Power steering – steering cylinder
5a: Valve block – lift cylinder
5b: Valve block – lift cylinder
6a: Valve block – Cutting deck coupling
6b: Valve block – Cutting deck coupling
7: Filter – hydraulic oil cooler
To do a check of the oil level in the
hydraulic system
1. Tilt the seat forward. Refer to
(P 520DX, P 525DX) on page 23 .
2. Clean the area around the oil tank cap with a dry
cloth.
3. Remove the oil tank cap and examine the hydraulic
oil level. Correct level is 40–60 mm from the top of
the strainer.
4. If the oil level is too low, fill with the type of oil given
Technical data on page 60 .
in
To do a check of the oil level in the
bevel gear of the cutting deck
1. Park the product on a level surface.
2. Lower the cutting deck to mow position.
48
To tilt the seat forward
3. Put a clean metal rod into the gear housing. The
metal rod must be a minimum of 100 mm long and
maximum 3 mm in diameter.
4. Lower the metal rod to the bottom of the gear
housing.
5. Pull the metal rod out and read the oil level.
6. Measure the part of the metal rod that has oil on it.
There must be oil on 15 mm of the metal rod.
7. Fill with gearbox oil if the oil level is less than 15 mm
of the metal rod. Refer to
on page 50 for recommended oil.
To replace the oil in the bevel gear of
the cutting deck
1. Remove the cutting deck. Refer to
cutting deck on page 18 .
2. Put the cutting deck on its front edge and drain the
oil through the oil fill plug.
3. Drain the oil into a container.
4. Fill with 80 ml new hydraulic oil as given in
data on page 60 .
5. Do a check of the oil level. Refer to
the oil level in the bevel gear of the cutting deck on
page 48 .
To do a check of the coolant level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover. Refer to
cover on page 32 .
3. Open the coolant cap.
Quick maintenance guide
To remove the
Technical
To do a check of
To open the engine
1593 - 005 - 25.10.2021