Husqvarna P 520DX Manuel D'utilisation page 46

6. Turn the oil filter counterclockwise to remove it.
7. Lightly lubricate the rubber seal on the new oil filter
with new oil.
8. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
9. Fill with new oil as given in
60 .
10. Start the engine and let it run at idle speed speed for
3 minutes.
11. Stop the engine and make sure that the oil filter does
not leak.
12. Do a check of the oil level.
Note:
For safe disposal of used engine oil, see
Disposal on page 59 .
46
Technical data on page
To do a check of the transmission oil
level
1. Use the oil dipstick to read the oil level in the
transmission.
2. The oil level must be between the marks on the
dipstick.
3. If the oil level is too low, fill with the type of oil given
Technical data on page 60 .
in
1593 - 005 - 25.10.2021