Husqvarna P 520DX Manuel D'utilisation page 14

1. Try to start the engine with the drive of the blades
engaged. If the operation conditions works, the
engine does not start.
2. Try to start the engine without the parking brake
applied. If the operation conditions works, the engine
does not start.
3. Start the engine, engage the drive on the blades and
lift from the seat. If the operation conditions works,
the blades in the cutting deck stop.
To do a check of the forward pedal and rearward pedal
1. Make sure that the forward and rearward pedals are
not blocked and can be operated freely.
2. Release the forward pedal to brake.
3. Make sure that the product brakes when the forward
pedal is released.
4. For more brake power, push the rearward pedal.
5. Do the same procedure for the rearward pedal.
Parking brake
WARNING:
not work, the product can start to move and
cause injury or damage. Make sure that the
parking brake is regularly examined and
adjusted.
To do a check of the parking brake on page
Refer to
35 .
Muffler
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Do not use the product if the muffler is missing or
defective. A defective muffler increases the noise level
and the risk of fire.
WARNING:
hot during and after use and when the
engine operates at idle speed. Be careful
near flammable materials and/or fumes to
prevent fire.
To do a check of the muffler
• Examine the muffler regularly to make sure that it is
attached correctly and not damaged.
Protective covers
Missing or damaged protective covers increase the risk
of injury on moving parts and hot surfaces. Do a check
of the protective covers before you operate the product.
Make sure that the protective covers are correctly
attached and do not have cracks or other damages.
Replace damaged covers.
14
If the parking brake does
The muffler becomes very
Power switches for safety signals - P 525DX Cabin
The power switches for safety signals are found on the
panel to the left of steering wheel.
• Horn (A)
• Parking lamp (B)
• Low beam lights (C)
• Turn signal (D)
• Hazard lights (E)
C
B
A
To cut grass on slopes
WARNING:
instructions that follow before you use the
product.
• To cut grass on slopes increases the risk that you
can not control the product and that it overturns. This
can cause injury or death. It is necessary to cut the
grass carefully on all slopes. If you cannot reverse
up a slope or if you do not feel safe, do not cut it.
• Remove stones, branches and other obstacles.
• Cut up and down the slope, not from side to side.
• Do not move down a slope with the cutting deck
lifted.
• Do not operate the product on ground that slopes
more than 10°.
• Do not start or stop on a slope.
• Move smoothly and slowly on slopes.
• Do not make sudden changes in speed or direction.
D
E
Read the warning
1593 - 005 - 25.10.2021