Husqvarna P 520DX Manuel D'utilisation page 18

3. Connect the hydraulic hoses to the coupling on the
product. The flange and the notch must line up
correctly.
Note:
The position of the hydraulic hoses controls
the operation function of the cutting height lever. To
change the operation function of the cutting height
lever, change the position of the hydraulic hoses.
To remove the cutting deck
1. Park the product on level ground.
2. Stop the engine.
3. Move the cutting height lever forward and rearward
2–3 times to release remaining pressure.
4. For Combi 132 X and Combi 155 X, release the
couplings and disconnect the hydraulic hoses.
5. Apply the parking brake.
6. Move the lift lever forward to lower the cutting deck.
Stop before the pivot wheels of the cutting deck
touch the ground.
7. Pull the spring (A) and remove the lifting eyes (B).
8. Start the engine.
18
B
A
9. Put the lift lever to the position (C) to lower the lift
arms.
C
D
WARNING:
in the mow position (D). The hydraulic
force can cause serious injury.
10. Stop the engine.
11. Remove the 2 screws and the service hatch.
12. Lift off the rubber casing from the shaft joint.
13. Pull back the coupling of the drive shaft and remove
the drive shaft from the bevel gear shaft of the
cutting deck and from the PTO shaft.
14. Remove the lock chains.
15. Remove the pins (E) and the bolts (F) from the lift
arms.
E
Do not put the lift lever
F
E
F
1593 - 005 - 25.10.2021