Husqvarna P 520DX Manuel D'utilisation page 20

13. Disconnect the hoses for the cabin heat.
14. Remove the 2 screws and the 2 washers behind the
seat (A).
B
15. Remove the screw and the washer behind the hoses
for the cabin heat (B).
16. Remove the screw and the washer at the front of the
door (C).
17. Fold the seat forward.
18. Put 2 straps through the door and the emergency
exit.
19. Put the straps 2 turns through the cabin.
20
A
C
20. Attach the straps in the lifting eyes of the cabin.
21. Carefully lift the cabin in the straps with a lift.
22. Lift the cabin 10 cm above the product.
CAUTION:
is lifted above the bolts.
23. Carefully move the cabin forward.
24. Put the cabin in the cabin support. Refer to
of the cabin on page 58
WARNING:
installed when the cabin is removed.
Refer to
Roll Over Protection Structure (ROPS)
on page 21 .
25. Install in the opposite sequence.
To remove and install the door
1. Open the door 90 degrees.
2. Pull out the gas spring and loosen the ball joint.
3. Lift the door to remove it.
4. Install in the opposite sequence.
To remove and install the emergency door
1. Open the lock handle on the emergency door.
2. Remove the hinge pin.
3. Open the door 90 degrees.
4. Lift the emergency door to remove it.
5. Install in the opposite sequence.
Make sure that the cabin
Storage
ROPS must be
To engage and disengage the
1593 - 005 - 25.10.2021