Husqvarna P 520DX Manuel D'utilisation page 25

4. Move the throttle control to the middle position.
5. Turn the ignition key to the ON position. Wait for the
display lights to come on.
6. Turn the ignition key to the arrow position. Hold it in
this position until the engine starts.
7. When the engine starts, immediately release the
ignition key to the ON position, to prevent damage to
the starter.
ON
CAUTION:
more than 6 seconds at a time. If the
engine does not start, wait 15 seconds
before you try again.
8. Let the engine run at ½ throttle for 3-5 minutes
before you apply a heavy load.
9. Push the throttle control to full throttle position.
CAUTION:
the engine is at full speed causes strain on
the drive belts and the clutch. Do not apply
full throttle until the cutting deck is lowered
to the mow position.
To operate the product
1. Start the engine.
1593 - 005 - 25.10.2021
Do not run the starter for
To engage the blades when
2. Release the parking brake.
3. Carefully push down one of the pedals. The speed
increases the more the pedal is pushed down. Use
pedal (A) to move forward, and pedal (B) to move in
reverse.
A
4. Release the pedal to brake. To brake harder, push
down the other speed pedal.
5. Pull the PTO button to engage the operation of the
blades on the cutting deck.
To set the forward pedal positions (P 525DX,
P525DX Cabin)
The forward pedal can be set to transport speed or
working speed using the lock lever.
B
25