Husqvarna P 520DX Manuel D'utilisation page 19

To remove and install the cabin
1. Remove the cabin door. Refer to
install the door on page 20 .
2. Remove the emergency door. Refer to
and install the emergency door on page 20 .
3. Remove the rubber straps and open the engine
cover.
4. Disconnect the battery.
5. Remove the service lid. Refer to
service lid on page 33 .
6. Remove the cover of the fuse box. Refer to
remove the cover of the control box on page 33 .
7. Disconnect the cable for cabin control. The cable
has a black plug.
8. Put the rubber grommet in the empty slot.
1593 - 005 - 25.10.2021
To remove and
To remove
To remove the
To
9. Disconnect the 2 connectors from the headlight
switch.
10. Remove the cable bridge from the connector and
install the connector on the headlight switch.
11. Turn the headlight switch ON and OFF to make sure
the headlights work correctly.
12. Put a cloth below the hoses for the cabin heat.
Note:
To prevent coolant leakage, make sure that
the cabin heat is off before you disconnect the
hoses.
19