Husqvarna P 520DX Manuel D'utilisation page 24

CAUTION:
correctly the hydraulic pump may be
damaged.
g) Tighten the locknuts.
4. To adjust the rearward pedal do the steps that
follow.
a) Turn the adjustment screw (C) on the wire to
adjust the position of the rearward pedal.
b) Push the pedal to full reverse. There must be a
10 mm clearance between the rearward pedal
and the foot plate.
To lift the cutting deck
1. Push the PTO button to disengage the drive of the
cutting deck.
2. Move the lift lever to transport position to lift the
cutting deck.
Note:
You can lift the cutting deck a small
distance with the drive on the blades engaged. Use
this function for very long grass or rough surfaces.
WARNING:
while the drive is engaged can throw
objects and cause serious injury or
death.
24
If this is not done
Lifting the cutting deck
To lower the cutting deck to the mow
position
1. Move the lift lever for hydraulic lift forward to lower
the cutting deck to the mow position (A).
A
2. Pull the PTO button to engage the drive on the
cutting deck blades.
To start the engine
1. Push down and turn the main switch to the ON
position.
2. Apply the parking brake.
3. Push the PTO button to disengage the operation of
the cutting deck.
1593 - 005 - 25.10.2021