Hot Water Programming - 1St Group; Hot Water Programming - 2Nd Group; Dose Programming With Key; Pre-Infusion Programming - Bezzera ELLISSE PM Manuel D'instructions

5.7.1 Hot water programming
- 1st group
Tea programming is similar to the dose program-
ming.
Get in programming and press the desired tea
touch-pad; when the delivered quantity corre-
sponds to the required quantity press again the
same touch-pad.
5.7.2 Hot water programming -
2nd group
Tea programming is similar to the 1st group pro-
gramming.
Get in programming and press the desired tea
touch-pad ; when the delivered quantity corre-
sponds to the required quantity press again the
same touch-pad.
At the close of the programming wait at least 5
seconds before starting the selection.
The memorized data are permanentely kept in
memory also in total absence of mains voltage.
The system allows the contemporary delivery of
tea during the delivery of coffee.
N.B.: 1 group machines own one hot water
dose; 2, 3 and 4 groups machines own two hot
water dose.
FIG. 10 - Machine start up switch and dose programming with key

5.7.3 Dose programming with key

Set the programming key (Fig.10; pos. 1) to po-
sition B and start the programming as shown in
chapter 5.7. At the end of the programming reset
the programming key to the normal position A.

5.7.4 Pre-infusion programming

There is the possibility to select the function "PRE-
INFUSION".
Machine OFF. Switch on the machine keeping
pressed:
-touch-key "a" (Fig. 7 - B; ELLISSE DE - Fig. 7
- C; ELLISSE TE) of the 1st group TO ENABLE
THE PRE-INFUSION.
- touch-key "b" (Fig. 7 - B; ELLISSE DE - Fig.
7 - C; ELLISSE TE) of the 1st group TO TAKE
OFF
THE PRE-INFUSION.
The system confirms the operation keeping alight
the leds " pos. f ". Switch off the machine and
then switch it on once again. Check the desired
setting.
The pre-infusion phases you use are the ones you
program.
26
ELLISSE
MOD.