Coffee Preparation; Hot Water Delivery; Steam Delivery - Bezzera UNICA Manuel D'instructions

5.3 Coffee preparation

1) Wait for the attainment of the ideal tempera-
ture for brewing coffee, indicated by the red
dot going OFF (Fig. 08, pos. 4) in the lower
right corner of the display (Fig. 08, pos. 2).
2) Remove the filter-holder of the machine and
introduce the ground coffee with the proper
measuring spoon (Fig. 02; pos. 18), into the
filter holder (Fig. 02; pos. 16) with one or two-
cup filter (Fig. 02; pos. 19/1-2) depending on
the desired number of coffees; eventually press
the coffee powder by applying a slight pres-
sure with the appropriate tamper (Fig. 02; pos.
17).
3) Reconnect the filter holder to the assembly
(Fig. 01; pos. 2).
4) Place the cup under the coffee delivery spout.
5) Raise the brewing coffee lever (Fig. 01; pos. 8)
until the desired coffee quantity is reached.
6) Lower the brewing coffee lever (Fig. 01; pos.
8) to stop delivery.
Warnings:
- Do not remove the filter-holder when the ap-
pliance is working, the delivery assembly is
pressurized.
- Do not touch directly the metal part of the filter
holder because it is hot.
- The standard doses for the filters are 6/8
grams for a dose and 12/14 grams for two
doses.

5.4 Hot water delivery

Failure to close the tap after normal
operation can result in damages to the
heating element for which the Manufac-
turer is not responsible.
1) Position the water container under the dispens-
er (Fig. 01; pos. 3).
2) Press and hold the water/steam tap knob (Fig.
05, pos. 1); raising the lever the tap will re-
main in the open position and activate the
pump switch (Fig. 05; pos. 2).
All manuals and user guides at all-guides.com
3) When the desired amount of water is deliv-

5.5 Steam delivery

Failure to close the tap after normal
operation can result in damages to the
heating element for which the Manufac-
turer is not responsible.
For steam delivery perform the following opera-
tions:
1) Press and hold "+" (Fig. 08, pos. 3) until
2) Press and hold the water/steam tap knob (Fig.
3) Close the water/steam tap (Fig. 05, pos. 1)
4) Dip the steam/water delivery pipe (Fig. 01;
5) After heating the drink, discharge a little steam
6) After steam delivery is over, release the water/
27
MOD. BEZZERA UNICA
ered, close the water/steam tap (Fig. 05, pos.
1) and turn off the pump switch (Fig. 05, pos.
2).
Do not touch the water/steam distribu-
tor tap directly as it is hot.
the display (Fig. 08, pos. 2) shows "c -> s"
indicating the transition from coffee mode
to steam mode. The PID digital temperature
control will adjust the boiler temperature to the
preset value for the steam and the display will
indicate that the transition has been completed
showing intermittently "StE" and the tempera-
ture in the boiler.
05, pos. 1); raising the lever the tap will remain
in open position; discharge water for about 10
seconds from the water/steam delivery nozzle
(Fig. 01, pos. 3) in order to partially drain the
boiler to allow the expansion of the volume of
steam and to prevent backflows of liquid in the
boiler.
and wait until the red dot (Fig. 08, pos. 4)
in the lower right corner of the display goes
OFF.
pos. 3) into the drink to heat and open the
steam/water tap (Fig. 05; pos. 1).
to clean out the sprayer hole.
steam tap knob (Fig. 05, pos. 1), remove the
container of the liquid and immediately clean
with a damp cloth the steam nozzle to remove