Use Of The Machine; Machine Start And Water Supply; Heating; Coffee Preparation - Bezzera ELLISSE PM Manuel D'instructions

ELLISSE
MOD.

5 - USE OF THE MACHINE

5.1 Machine Start and Water Sup-
ply
(Fig. 06)
Turn on the water supply tap.
Set the omnipolar lever switch to ON.
With the switch (1) in position 1, the water is loa-
ded into the boiler; after 120 seconds, the indi-
cators LED on the keypad will light up; repeat the
operation by acting on the same switch for some
times until the pump completely loads the boiler
and stops.
Once the minimum level has been reached, the
red light (Fig 6; pos 4) will light off and with the
switch in position \/\/\, the yellow lamp will li-
ght on (3).
N.B.: do not place the switch in
\/\/\ position when the red pilot
lamp is on.
Wait for the boiler manometer (10) to show a
pressure value ranging between 1 and 1,2 bar
before using the machine.

5.2 Heating

(Fig. 06)
In order to have the right temperature for the ma-
chine, make sure that the pressure on the gauge
is from 1 to 1,2 bar, then turn the steam knob (7)
and let out 2 or 3 times the steam into the drain
tray.
The green light (Fig. 1; pos. 3) if on, points out
the activation of the machine.
The red light (Fig. 6; pos. 4) if on, points out that
the water in the boiler is not enough.
The yellow light (Fig. 6; pos. 3) if on, points out
the activation of the heating element.
CAUTION!
When the red light (Fig. 6; pos. 4) is on a safety
device prevents the machine from operating; ask
for the technical assistance service.

5.3 Coffee Preparation

ELLISSE PM
1) Remove the filter holder from the supply
group.
2) Put the ground coffeee into the filter holder,
press it and make attention that the filter holder
edge is not dirty with coffee.
3) Replace the filter holder in its housing.
4) Press the ON/OFF key (Fig. 7 - A; pos. a) to
start the coffee supply.
Press again the ON/OFF key to stop the coffee
supply.
ELLISSE DE
1) Remove the filter holder from the supply
group.
2) Put the ground coffeee into the filter holder,
press it and make attention that the filter holder
edge is not dirty with coffee.
3) Replace the filter holder in its housing.
4) Press the proper touch-key (Fig. 4; B) on the
dose control board to supply coffee.
To change the dose programming, follow the
instructions described in the chapter 5.7 of this
booklet.
The machine is preset to supply coffee in "non-
stop mode":
1) Press the "non-stop mode" key to start the sup-
ply (Fig. 7 - B; pos. f).
2) Press again the "non-stop mode" key (Fig. 7
- B; pos. f) to stop the coffee supply.
CAUTION!
The machine is equipped with an automatic sa-
fety device that stops the nonstop
supply after deliverying three consecutive liters.
ELLISSE TE
1) Remove the filter holder from the supply
group.
2) Put the ground coffeee into the filter holder,
press it and make attention that the filter holder
edge is not dirty with coffee.
3) Replace the filter holder in its housing.
4) Press the proper touch-key (Fig. 7 - C)
24