Steam Supply; Picking Up Of Hot Water; Turning Off The Machine; Programming Of Doses (Ellisse De/Te) - Bezzera ELLISSE PM Manuel D'instructions

BEZZERA ELLISSE
MOD.
put key (Fig. 07- B pos. f)
2) stop the output once the wanted quantity has
been reached, by pressing once again the
continuous output key (Fig. 07- B pos. f)
Warning: The machine is equipped
with an automatic safety device that
stops continuous output after the third
consecutive litre.
ELLISSE TE
1) Remove the filter holder from the supply
group.
2) Load the filter holder with ground coffee, press
the coffee paying attention not to dirty the bor-
der of the filter holder.
3) Hook back the filter holder in its location.
4) Act on the coffee supply command, by press-
ing one of the keys (Fig. 07-C), based on the
dose to supply.
To change the programming of doses, follow the
instructions indicated in paragraph 5.7 of this
booklet.
The machine is also conceived for continuous
output:
1) start the output by pressing the continuous out-
put key (Fig. 07- C pos. f)
2) stop the output once the wanted quantity has
been reached, by pressing once again the
continuous output key (Fig. 07- C pos. f)
Warning: The machine is equipped
with an automatic safety device that
stops continuous output after 600 sec-
onds.

5.4 Steam supply

1) To avoid refluxes of fluid inside the boiler, ex-
haust the steam by acting on the tap's knob
(fig. 01; pos. 3).
2) Introduce the steam nozzle (Fig. 01; pos 2) in
the fluid container to heat up.
3) Press the steam key (Fig. 01 pos 3). The quan-
tity of steam supplied is proportional to the
opening of the tap; the greater is the opening
of the tap, the greater the quantity of steam
supplied will be.
All manuals and user guides at all-guides.com
(Fig. 07-C)
34
4) Once the output of steam is concluded, re-
move the fluid container and clean immedi-
ately the steam nozzle with a wet cloth from the
residues of the heated fluid.
Warning: Do not touch the steam nozzle directly
because it is hot.

5.5 Picking up of hot water

ELLISSE PM
1) Position the water container under the nozzle
(Fig. 01; pos 6).
2) Act on the tap (Fig. 01; pos 7a) to pick up the
quantity of water needed.
ELLISSE DE
1) Position the water container under the nozzle
(Fig. 01; pos 6).
2) Press key (Fig. 01 - B; pos e) to pick up the
quantity of water needed.
ELLISSE TE
1) Position the water container under the nozzle
(Fig. 01; pos 6).
2) Press key (Fig. 01 - C; pos e) to pick up the
quantity of water needed.
Warning: Do not touch the nozzle directly be-
cause it is hot.

5.6 Turning off the machine

1) Close the water shut-off valve
2) Bring the switch (Fig. 06; pos 1) in pos 0 and
check that the green light is off.
3) Bring the omnipolar switch of the electric net-
work in idle position "0".
4) Exhaust the pressure of the steam tap.
5.7 Programming of doses (ELLISSE
DE/TE)
To adjust doses in DE/TE machines, proceed as
follows:
press the continuous output /programming/stop
key (Fig. 07 B/C post f), keep it pressed until the
relative light starts flashing, notifying (the machine
must not supply water) the beginning of the pro-