Trouble Shooting; Problem / Diagnostics/Solution / Advices - Bezzera ELLISSE PM Manuel D'instructions

7 – TROUBLE SHOOTING
Problem
No output of steam from the
relative tube
Leaks from filter holder
Difficulty in positioning the filter
holder on the hooking ring
Improper position of the filter
holder once assembled on the
group
The flow of coffee is scarce.
All manuals and user guides at all-guides.com
Diagnostics/Solution
The nozzle of the steam tube is
clogged; unclog it with needle.
This problem is linked to the
introduction of the spout inside
the milk.
Possible causes:
1 – The group gasket is worn or
encrusted.
2 – The filter holder is positioned
improperly on the group.
The problem can be caused by
the excessive dose of coffee in
the filter holder.
The handle of the filter holder
is shifted on the right, once
assembled on the group. The
group gasket is worn out.
The coffee is supplied drop by
drop, the output time is too long
and the quality of it is not good,
the cream is dark.
Possible causes:
1 – The grinding of coffee is too
thin.
2 – The coffee in the filter hold- The coffee in the filter hold- The coffee in the filter hold-
er has been pressed too
much.
3 – The dose in the filter holder
is excessive.
4 – The group's
clogged.
5 – The filter in the filter holder
is clogged.
6 – The pressure supplied by the
pump is low (< 9 bar – 0.9
MPa) or null.
37
MOD.
Clean the steam spout after
each use.
Clean it by using the brush sup-
plied. Should the problem occur
again, call a specialized techni-
cian
Decrease the quantity of coffee
in the filter holder.
Call a specialized technician to
substitute the group gasket.
In cases 1-2-3, the problem can
be solved by adjusting grinding
and/or dosing.
In cases 4-6, a technician must
be consulted.
In the 5th case, clean the filter
or substitute it.
spout is
BEZZERA ELLISSE
Advices