Steam Distribution (Fig. 06); Drawing Hot Water; Turning Off The Machine; Pressure Gauge - Bezzera MAGICA Manuel D'instructions

and the drying of the coffee.
Caution:
- Do not remove the filter holder filled with cof-
fee when the equipment is operating.
- Do not touch expressly the metal plating of the
filter holder; danger of burns.
- The standard doses for the filters are 8 grams
for a dose and 16 grams for two doses.
5.4 Steam distribution
1) To avoid liquids being sucked into the boiler,
discharge the steam by turning the tap knob
(Fig. 01; pos. 9).
2) Insert the steam nozzle (Fig. 01; pos. 8) in the
container of the liquid to be heated.
3) Press down and hold the steam tap knob (Fig.
01; pos. 9), lifting the lever the tap will remain
in open position (Fig. 06). The amount of steam
distributed is proportional to the opening of
the tap; the more the tap is opened, the more
steam will be distributed.
4) Once steam has been distributed, release
knob, remove liquid container and clean the
steam nozzle immediately with a damp cloth to
remove heated liquid residues.
5) Open the steam tap (fig. 01; pos. 9) (approxi-
mately 2 / 3 seconds) in order to purge and
clean also inside the steam nozzle.
Warning:
Do not touch the steam nozzle directly as it is hot.

5.5 Drawing hot water

1) Place the water container under the nozzle (Fig.
01; pos. 3).
2) Press down and hold the water tap knob (Fig.
01; pos. 10) to draw the amount of water re-
quired.
3) Once water has been distributed, release the
knob.
Warning:
Do not touch the water distributor tap directly as
it is hot.

5.6 Turning off the machine

(Fig. 06)
29
BEZZERA MAGICA - MITICA
MOD.
1) Turn the main switch (Fig. 01; pos. 1) to posi-
tion "0" and check that the light (Fig. 01; pos.
11) has turned off.
2) Turn off the intercepting water tap (R version).

5.7 Pressure gauge

The machine is equipped with dual pressure
gauge by which you can check the following pres-
sures:
Boiler manometer (Fig. 01, pos. 14)
range 0~3 bar (0~0,3 MPa)
The boiler manometer indicates the boiler pres-
sure.
Pressure gauge (Fig. 01; pos. 15)
range 0~15 bar (0~1,5 MPa)
The pressure gauge indicates the pump maximum
pressure during operation. When the motor pump
is stopped the manometer indicates the water sup-
ply pressure (R version) or "0" (S version).

5.8 Turning on the lights

(where expected)
The espresso coffee maker is equipped with a
rear illumination device. To activate illumination,
press the switch (Fig. 01; pos. 20) located under-
neath the machine.

6 - MAINTENANCE

To allow the machine to work correctly, follow the
maintenance instructions provided below.

6.1 Safety rules

Do not subject the machine to water jets. Discon-
nect the machine from the electrical power by turn-
ing the electrical power network omnipolar knife-
switch lever to the resting position 0. Remove the
plug and close the water interception tap before
carrying out maintenance and/or cleaning work.
If the machine is malfunctioning, do not attempt
to repair it alone and call the technical assistance
service immediately. If the electrical power cable
has been damaged, turn off the machine immedi-
ately, turn off the water and call the technical as-
sistance service. Do not replace it alone. Carry out
cleaning/maintenance when the machine is cold,
preferably wearing protective gloves.