Inserting Batteries Into The Remote Control; Using The Remote Control; Pal/Ntsc Conversion; Turning On The Power - Yamaha DV-SL100 Mode D'emploi

Inserting batteries into the Remote
Control
Open the battery cover by pressing in the tab, then lift off
1
the cover.
Insert batteries with the correct polarity as indicated by
2
the + and - symbols inside the battery compartment.
Close the cover.
3
CAUTION!
– Remove batteries if they are exhausted or not to
be used for a long time.
– Do not use old and new or different types of
batteries in combination.
– Batteries contain chemical substances, so they
should be disposed off properly and kept away
from children.

Using the Remote Control

● Direct the remote control at the remote sensor of the
DVD player.
● Do not drop or give the remote control a shock.
● Do not leave the remote control in extremely hot or
humid places.
● Do not spill water or put anything wet on the remote
control.

PAL/NTSC Conversion

This player is equipped with a PAL/NTSC conversion
feature to convert the video output of the disc to match
your TV system. The conversions supported are as
below. To activate the conversion, refer to "TV TYPE":
Type
DVD
+
VCD
-
Notes:
– "MULTI" can only be selected when using a TV that has
both the PAL and NTSC systems.
– Slight picture distortions may occur due to this conversion.
This is normal. Thus, the "MULTI" is most suitable for the
best picture quality.

Turning on the power

Connect the AC power cord to the power outlet.
1
Turn on the TV and your AV receiver.
2
Select the appropriate input source at the AV receiver
3
that was used to connect to this unit. Refer to the
equipment owner's manual for detail.
Turn this unit on.
4
Set the TV to the correct Video IN channel. (eg. EXT1,
5
EXT2, AV1, AV2, AUDIO/VIDEO, etc. (Refer to your TV
owner's manual for detail)
➜ The front display lights up and the default screen
appears on the TV.

Smart Power On/Off

When in STOP or NO DISC mode, the DVD player will
switch to standby mode after 15 minutes without any
operations for saving energy. It is easily reactivated by
pressing the POWER or PLAY on the remote control or
the STANDBY/ON button on the front panel.
Preparation
Disc Output format
Selected mode
Format
PAL NTSC
PAL PAL NTSC
NTSC
PAL NTSC
PAL
PAL NTSC
NTSC PAL NTSC
MULTI
PAL
NTSC
PAL
NTSC
7