Getting Started; Inserting Batteries Into The Remote Control; Using The Remote Control; Turning On The Power - Yamaha DVD-C950 Mode D'emploi

Step 1: Inserting Batteries
into the Remote Control
3
1
2 2
1 Open the battery compartment.
2 Insert two type R06 or AA batteries,
following the indications (+/–) inside the
compartment.
3 Close the cover.

Using the remote control

Point the remote control
at the sensor, within
approximately 6 m
(20 feet) of the player.
Handling the remote control
• Do not spill water or other liquids on
the remote control.
• Do not drop the remote control.
• Do not leave or store the remote
control in the following types of
conditions:
– high humidity, such as near a bath
– high temperature, such as near a heater
or stove
– extremely low temperatures
– dusty places
Remote control
sensor

Getting Started

Getting Started
Step 2: Turning on the
Power
1 Connect the AC power cord to an AC
outlet.
2 Turn on your TV and AV receiver.
3 Select the appropriate input source at the
AV receiver that was used to connect to
this player. Refer to the owner's manual
for your component for details.
4 Turn on this player.
5 Set the TV to the correct Video IN
channel. (e.g. EXT1, EXT2, AV1, AV2,
AUDIO/VIDEO, etc. Refer to the owner's
manual for your TV for details.)
The front display lights up and the
default screen appears on the TV.
Step 3: Selecting a Color
System for Your TV
This player is compatible with both NTSC
and PAL video formats. Select the color
system that matches your TV.
VIDEO SETUP PAGE
TV TYPE
TV DISPLAY
BLACK LEVEL
CLOSED CAPTION
PICTURE SETTING
ADV PICTURE
1 Press SETUP.
2 Press 2 repeatedly to select [VIDEO
SETUP PAGE].
3 Press 34 to highlight [TV TYPE], then
press 2.
PAL
NTSC
MULTI
11