Yamaha DVD-C950 Mode D'emploi page 30

Setup Menu
To input your favorite tracks/
chapters
3 Use the numeric keypad (0-9) to enter
a valid track/chapter number.
4 Use 1 234 to move the cursor to the
next position.
If the track number is more than ten,
press T to open the next page and
proceed with programming or,
Use 1 234 to highlight [NEXT] on the
program menu, then press ENTER/
OK.
5 Repeat steps 3–4 to input another track/
chapter number.
To remove a track
6 Use 1 234 to move the cursor to the
track you want to remove.
7 Press ENTER/OK to remove this track
from the program menu.
Note:
– On SA-CD discs, you can program tracks on
the CD layer.
Program: Disc
You can playback discs in the order you
want by programming the discs to be
played. You can store up to 5 discs.
1 In 'GENERAL SETUP PAGE', press 34 to
highlight [PROGRAM], then press 2 to
select [FDS].
2 Press ENTER/OK to confirm.
FAVOURITE DISC SELECTION
(1) DISC : _
(2) DISC : _
(3) DISC : _
(4) DISC : _
(5) DISC : _
START
TIPS: To return to the previous menu, press 1.
To clear the menu, press SETUP.
26
EXIT
To input your favorite discs
3 Use the numeric keypad (0-9) to enter
a valid disc number.
4 Use 1 234 to move the cursor to the
next position.
5 Repeat steps 3–4 to input another disc
number.
If you want to remove a disc
6 Use 1 234 to move the cursor to the
disc you want to remove.
7 Press 0 on the numeric keypad (0-9) to
remove this disc from the program menu.
To start program playback
• Use 1 234 to highlight [START] on
the program menu, then press ENTER/
OK.
Playback starts for the selected tracks
or discs in the programmed sequence.
To exit program playback
• Use 1 234 to highlight [EXIT] on the
program menu, then press ENTER/
OK.