Reading The Running Hours Counter; Care And Maintenance - Tractel tirak T 1000 Manuel D'installation Et De Manutention Original

If a general overhaul has been carried out then the period com-
mences anew.
A general overhaul of the hoist must only to be undertaken by
TRACTEL Greifzug GmbH or a hoisting gear workshop that has
been approved by TRACTEL Greifzug GmbH.
Contact TRACTEL Greifzug GmbH or your supplier with regards
to this test.
Exceptional tests
After an emergency descent, the hoist must always be tested in
manual mode by TRACTEL Greifzug GmbH or a hoisting gear
workshop that has been authorized by TRACTEL Greifzug
GmbH (see ' 10.3 Emergency descent' on page 16).
Any damaged or worn part found must always be replaced.

15.3 Reading the running hours counter

The running hours counter is located in the hoist's terminal box.
The running hours counter counts the time in which the hoist is in
operation as running hours (UPWARD or DOWNWARD move-
ments).
DANGER!
Danger of death due to electric shock!
– Disconnect the hoist from the power supply by pulling out
the plug.
– Pull out the power plug.
– Open the terminal box.
– Read the running hours counter:
– Note the running hours in the logbook.
– Close the terminal box.

15.4 Care and maintenance

Interval Work
Daily
– Check the anchorage of the
hoist
– Inspect the rope for clinging
dirt
Weekly Check the rope, see page 19 Operating person-
–
– Check the connecting cable
and control cable
Every 50
– Traction sheave external
running
teeth (only model series
hours
X 3050), see page 20
1 x annually –
Hoist safety inspection
G932.4 - 09/2015
Interval
250 / 500
1)
Running
hours / after
10 years
Whenever
necessary
Devices with 12 or 18 m/min rope speed
1)
Devices with 6 or 9 m/min rope speed
2)
Depending upon which occurs first
3)
Rope
Risk of injury through stabs and cuts!
Broken wires in the wire rope can result in protruding wires!
Protruding wires can cut or stab through safety gloves!
– Wear suitable leather protective gloves when working
with wire ropes.
– Never let the wire rope run through your hands.
Cleaning
Brush the dirt off soiled ropes when dry if necessary. Re-lubricate
as necessary.
Use the brush attachments to clean the rope at the hoist in an
extremely dirty environment.
Lubrication
Danger of falling and danger from falling objects due to
slippery or damaged ropes or brake failure and malfunc-
Implementation
tions!
Operating person-
Might result in severe injuries or even death!
nel
– Do not lubricate the rope using a lubricant that contains
disulfide (e.g. Molycote
– Use multi-purpose grease or oil.
– Cleaning the rope or products in contact with the rope
using high pressure cleaners is prohibited! Moisture will
nel
result in malfunctions and damage to the motor, brake
and the electrical equipment.
– Dirt on the wire rope will result in premature wear or the
Operating person-
corrosion of the wire rope, rigging and hoist.
nel
Replacement
Replace the ropes immediately if the withdrawal criteria in ac-
Authorized mainte-
cordance with Table 7 have been reached (as per ISO 4309 and
nance personnel
Installation and operating manual
Work
General overhaul of the hoist TRACTEL Greifzug
2) –
3)
See page 19:
– Clean the rope
– Lubricate the rope
– Replace the rope
– Replace the cable
DANGER!
DANGER!
).
®
Implementation
GmbH or a hoisting
gear workshop that
has been approved
by TRACTEL
Greifzug GmbH
Trained person
nominated by the
operator
Electrician
EN-19