Thd-Measurement (Harmonic Content); Lpf-Measurement (Low-Pass-Filter) - VOLTCRAFT VC731 Notice D'emploi

f) THD-Measurement (Harmonic Content)
• Move the setting wheel (7) to the icon for voltage measurement "
measurement "
current measurement in chapter 11. c) and 11 j).
• To measure the harmonic content (only possible at AC mode), select the symbol "THD"
with the navigation joystick (5). Confirm your selection by pushing the navigator joystick
("ENTER").
• The LC display indicates the value.
g) LPF-Measurement (Low-Pass-Filter)
• Move the setting wheel (7) to the icon for voltage measurement "
measurement "
current measurement in chapter 11. c) and 11 j).
• To indicate the LPF indicator (only possible at AC mode), select the symbol "LPF" with
the navigation joystick (5). Confirm your selection by briefly pushing the navigator
joystick ("ENTER").
• Terminate this mode by pushing the navigation joystick for at least 2 seconds ("ENTER").
• The LC display indicates the value.
58
" (VC732) or "
" (VC732) or "
" (VC731). Observe the information on voltage/
" (VC731). Observe the information on voltage/
" or current
" or current