Making A Measurement - VOLTCRAFT LX-1108 Mode D'emploi

Making measurements
Make sure you are a safe distant from hot sources of
light. There is risk of burning!
Never stare directly into a bright light source. This
could cause damage to your eyes
The Luxmeter has various extra functions that ease operation and
handling.
These extra functions are:
Auto power OFF function
In order to avoid that the operating life of the battery is shortened
unnecessarily, an automatic switch-off function has been imple-
mented. The device will be automatically turned off if no button is
pressed for longer than 10 minutes. You can switch the device back
on with the "Power" button.
The Auto-Power-OFF function is deactivated as soon as you go into
"REC" mode.
HOLD/Peak function
Pressing the "HOLD" button holds the measurement made at that
moment. Press again to switch back to the continuous measuring
mode.
A Peak has also been built in to measure continuous peak values.
Press the "HOLD" button for 2-3 seconds to go to this mode.
"HOLD" appears on the display. Only the momentary highest value
will be displayed. Press the "HOLD" button again for 2-3 seconds to
go out of this mode.
24