Intended Use - VOLTCRAFT LX-1108 Mode D'emploi

Intended use

The Luxmeter is a digital measuring instrument which can measure
light intensity in Lux units and in Foot-candle (Fc).
A graded filter can be selected for various light sources, in order to
measure the actual strength of light.
Measurements are made via a foto-element with a filter, that sepa-
rates the visible light spectrum in order to be measured. The resul-
ting measurements are shown in an LCD bar display as a value ran-
ging from 0 to 400000 Lux.
The momentary value can be held or the the minimum/maximum
values stored.
A series interface is available. A 9-V block battery (type 1604A) is
required for operation .
Measurements must not be carried out under unfavourable ambient
conditions.
The following are unfavourable ambient conditions:
- excessive dampness or humidity
- dust or combustible gases, vapours or solvents
- Electrical storms or stormy conditions and strong electrostatic
fields, etc
Use other than that described above will lead to damaging the pro-
duct.
No part of the product may be modified or converted!
The safety instructions should be observed without fail!
19