Rs232-Interface - VOLTCRAFT LX-1108 Mode D'emploi

- "Operational status (no symbol displayed)" for lamps. sunlight
or unknown light source,
- "FL" for fluorescent lamps,
- "Hg" for mercury vapour lamps
- "Na" for sodium vapour lamps.
You can switch between functions by continuously pressing the
button
• Place the sensor under the light source that is to be measured.
• Using the "RANGE" button select the appropriate measuring scale.
A dash line is displayed if the value is over or under the given range
(upper line = over measuring range; lower line = under measuring
range).
• After completing measurements press the "POWER" button for
approx. 2 seconds. The meter will then turn itself off.
• There is a fold-out stand on the rear of the Luxmeter. A socket is
also included to mount the device on a stand.

RS232-Interface

The Luxmeter is installed with a serial interface for exchanging data
with a computer. This can be found on the right hand side under the
lid. The interface is in the form of a 3.5mm jack plug socket and
requires a compatible data cable, which is an optional extra.
The data cable is made up of the following:
26