HIKOKI CS 3630DB Mode D'emploi page 18

English
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult
your dealer or the HiKOKI Authorized Service Center.
1. Power tool
Symptom
The motor sounds but the
saw chain...
○ does not move
○ does not move freely
Poor sharpness
Chain oil
○ is slow-fl owing
○ does not come out
(seizes up)
Battery cannot be
installed.
Possible cause
The chain brake may be activated.
The saw chain tension is excessive.
Saw chain comes out of the sprocket.
Inside the side cover...
→ sawdust is jammed
→ foreign matter is trapped
In the guide bar groove...
→ sawdust is jammed
→ oil does not fl ow
The saw chain...
→ is worn out or the blade is broken
→ is rusted
The direction of the saw chain is reversed,
Saw chain tension is loose.
Lack of chain oil in the tank.
Chain oil spout is clogged.
Attempting to install a battery other than
that specifi ed for the tool.
Release by pulling the chain brake toward
you.
Check the saw chain tension, and if it is
too tight, loosen the tension.
Check the saw chain is properly engaged
on the sprocket.
Clean the side cover.
Clean the guide bar groove and the oil
hole.
Make sure there is oil in the oil tank, and
replenish as required.
Sharpen the saw chain.
If the wear or breakage is very severe,
replace with a new saw chain.
Re-attach ensuring the correct direction.
Check the saw chain tension and tighten
if it is loose.
Replenish with chain oil.
Clean the chain oil spout.
Please install a multi volt type battery.
18
Remedy