Problems And Solutions - EUROM MULTICLIMA 90 Livret D'instructions

PROTECTION
The Multiclima is fitted with an overheating safeguard that switches
the unit off if it overheats. If this should occur, you must remove the
plug from the socket and leave to Multiclima to cool for at least 30
minutes. Remove the cause of overheating - has the device been
(partially) covered? Is it too close to a wall or another obstacle,
preventing it sucking in or dispelling sufficient air?
You can then use the device normally again but keep an eye on it for
the first 30 minutes to ensure there are no further problems. If the
device is showing signs of problems or the overheating recurs, even
though there is no obvious assignable cause, ask your supplier or a
recognised electrician to check/repair the unit.

PROBLEMS AND SOLUTIONS

The display will help diagnose what is wrong in certain
circumstances.
It will provide the following information code
E1 Short circuit in temperature sensor and printed circuit board.
Contact your supplier for repairs under guarantee.
E2 Short circuit in the copper wire from temperature sensor and
wiring from printed circuit board. Contact your supplier for
repairs under guarantee.
E4 The tank is full or the cap is not secured properly. Remove
the cap from the drainage point on the underside of the unit
and allow water to drain away. Make sure that the cap is
replaced correctly.
DISPOSAL
When the Multiclima eventually comes to the end of its
useful life and must be disposed of, it must not be
removed with ordinary household waste. Take it to a
special collection point organised by your local council.
Remove the batteries before doing so!
29