EUROM MULTICLIMA 90 Livret D'instructions page 31

place (the screws then fall within the recess) or 157mm, with 4
small holes for the screws. You can determine the location of the
screws using the back-plate.

Place the window plates on the appropriate sides over the hole
and screw them together.

Run the cable to the Multiclima and connect it to the connection
point (see page 6 point 7).

Place the Multiclima outdoors at a suitable location, see
Installation. Connect one end of the air outlet pipe to the side
opening on the side of the Multiclima that blows out cool air (if you
wish to use the cooling function) or to the opening that blows out
hot air (if you wish to use the heating function); the other side is
connected to the outdoor window plate.
Note: the air outlet hose is now positioned on the opposite side
compared to when the Multiclima is located indoors!

Make sure that all connections are secured properly, that the unit
is not damaged or broken and that the socket to which you wish to
connect the Multiclima is the same voltage as stated on the
device's specification plate. If you are using an outdoor socket, it
must fulfil the requirements of an outdoor electrical socket!

If everything is ok, insert the plug into the
socket.

You can now operate the Multiclima with the
digital remote control. Make sure that the
remote control is directed towards the receiver
in the indoor window plate!
Digital remote control
A digital remote control is supplied with the window
set. The same buttons are provided on this remote
control as can be found on the standard Multiclima
remote control; there is also a display that gives
the settings.
To use the digital remote control, you must point it
towards the receiver on the indoor window plate.
Note: The Multiclima has an insulation category of
IPX4. This means that it can withstand a few
raindrops but must never be exposed to
downpours or long periods of mist.
31