EUROM MULTICLIMA 90 Livret D'instructions page 26

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

7. Timer
Set the operating time for the Multiclima using this button.
Note: the timer can only turn the Multiclima off, it cannot start it!
If you wish to turn the Multiclima off using the timer, proceed as
follows:
 Set the Multiclima in the usual way by selecting the appropriate
function (cooling, heating or dehumidifying)
 Press once on the timer button: the display will blink and then
show the time set using the timer. If no time has been set, the
display will show '0'.
 Press the 'temp+' or 'temp-' buttons to set the required operating
time, up to a maximum of 24 hours. After setting, the display will
flash the set time for 8 seconds and then return to the set
temperature (not blinking).
 You can amend the time by pressing on the timer again and
using 'temp+' or 'temp-' to change the time. You can also cancel
the timer task by switching the unit off.
8. Sleep function
The sleep function will be selected if you press this button while
using the cooling function. After one hour, the set temperature will
be increased by one degree; it will increase by a further degree after
a second hour. This setting will be maintained. During the sleep
function, the fan works on low speed.
Press this button during heating and the set temperature will be
decreased by one degree after an hour and by a further degree after
a second hour. This setting will be maintained; the fan works on a
low speed.
The sleep function cannot be used during dehumidification.
9. Alarm
When the tank is full, the Multiclima stops
and the display shows 'E4'. Switch the
Multiclima off, remove the plug from the
socket and remove the rubber cap (2) on
the water outlet underneath the unit to
drain water (see Fig.). Replace the cap and
you can start the Multiclima as usual.
26

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Multiclima 120

Table des Matières