Cleaning And Maintenance - EUROM Cool Silent 90 Mode D'emploi

CLEANING AND MAINTENANCE

Note! Before cleaning or carrying out maintenance work on the air conditioning unit, always
switch off and remove the plug from the socket! Regular cleaning is vital in order to keep the
unit in good working order!
Cleaning the housing
Use a soft, damp cloth to wipe the housing.
Never use aggressive cleaning products, petrol, detergent, chemically-impregnated cloths or
other cleaning solutions. These could damage the housing. Never spray the unit and ensure
that water never penetrates the device! Dry the unit with a soft cloth.
Cleaning the filters
Clean the filters once every two weeks; a unit with
dirty filters will never work properly.
The 3 filters can be found behind the air inlet
grilles on the sides and at the rear. You can easily
open these grilles and remove the filters, see
image. Push filter C down a little and
simultaneously slide it outwards. You can then
remove filter B.
. Use a vacuum cleaner or gently beat the filter to
remove loose dust and dirt. Rinse the filter with
tepid water (not hotter than 40°C) with a mild,
neutral cleaning product. Let the filters dry
thoroughly in the shade before replacing in the
unit. Take care! Never use the air conditioning unit
without the filters!
If you do not clean the filters too long, the filter light will come on (see fig.). Clean the
filters and reset the light by pressing the SLEEP button for 3 seconds.
End of season cleaning
If the device is to be stored for a long period, you must take the following measures!
 Remove the condensed water. Run the unit for a few hours on fan function so that the unit is
completely dry inside.
Then switch the air conditioning unit off, remove the plug from the socket and:
 clean the filters and reposition them or replace with new ones;
 unscrew the waste pipe from the device in order to prevent damage;
 Remove the batteries from the remote control.
 pack the air conditioning unit in its original packaging or in a plastic bag and place in a dry
place for storage. Place a heavy object on the unit.
TROUBLE SHOOTING
The unit does not start if I press the ON/OFF button
 Is the plug in the socket?
 Is the earth leakage circuit breaker engaged? No power?
 Is the water tank full (P1)? Empty it.
 The room temperature is lower than the set temperature; amend the set temperature.
The unit doesn't seem to be very effective
 Is the temperature set too high? Lower it a little.
 There is insufficient coolant in the device. Contact your service centre.
 Is there direct sunlight? Shut the curtains.
25