Use With An External Dmx Controller - Renkforce 1086303 Notice D'emploi

b) Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires up to 28 DMX channels depending on DMX operating mode.
Setting the DMX operating mode
• If required, push the button MENU until the display is in the main menu.
• Push the button r or s until Chnd is displayed.
• Push the ENTER button for confirmation of your selection.
• Push the ENTER button again to get to the DMX operating mode selection.
• The DMX operating mode (xxCh) is displayed (xx defines the DMX operating mode).
• Set the DMX operating mode with the buttons r and s.
• Push the ENTER button for confirmation of your selection.
• Push the button MENU until the display is in the main menu again.
Setting the DMX starting address
• If required, push the button MENU until the display is in the main menu.
• Push the button r or s until Addr is displayed.
• Push the ENTER button for confirmation of your selection.
• Push the ENTER button again to get to the DMX starting address selection.
• The DMX starting address (Axxx) is displayed (xxx defines the starting address).
• Set the DMX starting address with the buttons r and s.
• Push the ENTER button for confirmation of your selection.
• Push the button MENU until the display is in the main menu again.
The following tables provide information about the different DMX operating modes and the effects of the
settings on the individual DMX channels.
DMX operating mode 3Ch (3-channel DMX operation)
DMX channel DMX Value
1 000-255
2 000-255
3 000-255
32
Function
Brightness red
Brightness green
Brightness blue