Use With An External Dmx Controller - Renkforce DL-LED107S Mode D'emploi

e) Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 3 or 6 free DMX channels depending on DMX operating mode.
Setting the DMX operating mode
• Set >> 6 ch in menu ChNd to operate the device in 6-channel DMX operation.
• Set >> 3 ch in menu ChNd to operate the device in 3-channel DMX operation.
Setting the DMX starting address
• Push the button FUNC until Addr is displayed and push the button ENTER.
• Select the desired starting address 001-507 with the UP and DOWN buttons.
• Confirm your selection again with ENTER.
The following tables provide information about the effects of the settings on the individual DMX channels.
6-channel DMX operation
DMX channel Value
1 000
001-255
2 000-015
016-255
3 000-127
128-255
4 000-255
5 000-255
6 000-255
3-channel DMX operation
DMX channel Value
1 000-255
2 000-255
3 000-255
Function
Light off
Overall brightness
Automatic operation off
Automatic operation slow > fast
Flashing effect off
Flash effect slow > fast
Brightness red
Brightness green
Brightness blue
Function
Brightness red
Brightness green
Brightness blue
27