Renkforce DL-LED107S Mode D'emploi page 21

Illuminated objects or surfaces must be at least 0,5 m away from the device's light emission
source. Easily flammable materials such as decorative fabrics must also have a distance of at
least 0,5 m to the device. Otherwise, such objects may catch fire!
When setting up/installing the device, make sure that the mains cable is not squeezed or dama-
ged by sharp edges.
During installation or service work, the area below the place of installation must be cordoned
off.
The setup/installation surface or fixture must be designed to carry ten times the load capacity
for at least one hour without any permanent damaging deformation.
Additionally, the device must be secured with a second independent safety fixture besides the
actual installation fixture when installed/set up in an elevated position. No part of the installa-
tion must fall down if the main suspension system fails.
Observe all relevant regulations of your country when mounting/installing the device.
Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical
connections) must be inspected by an official expert.
A yearly inspection by an expert is required.
At least every 4 years, an acceptance test must be carried out by an expert.
• Attach the two included mounting brackets to the casing with the lateral thumbscrews.
• If you want to set up the effect light, turn the two mounting brackets so that they form a base and then
tighten the two thumbscrews.
• If you want to suspend the effect light, turn the two mounting brackets upwards, so that the assembly
holes in the brackets match.
• Install the effect beamer on the ceiling, the wall or a suitable crossbeam with the mounting bracket. The
assembly must never swing freely.
• Secure the device with assembly equipment that is compatible with the attachment surface and suitable
for carrying the weight of the effect light.
• Additionally secure the installation with a suitable safety restraint cable or a safety net. The safety reten-
tion rope or the net must be designed to support the effect light in the event of failure of the main support
system independently of the main attachment.
• Set the desired inclination angle and tighten the thumb screws well.
21